Arctic Chat : Arctic Cat Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
We have an 2002 Arctic Cat Pantera 600 snowmobile. That is the engine with povervalves. Anyways, the cables that run the valves keep coming out of their mounts on the servo motor. I re-hooked them up and everything was correct. The valves were cleaned so they shouldn't be sticky. Any Ideas on why they keep popping off of their mounts?

Thanks.
 

·
Premium Member
Joined
·
5,566 Posts
Your cables are dirty are are causing the cable to come of the servo NOT the Valves

you might have rust build up in the cables

Been there done that

take the cable off both the servo and valves

and check how freely the cable moves

If they do not move freely .time to pony up $120 for new cables
 
1 - 2 of 2 Posts
Top