Arctic Chat : Arctic Cat Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
67 Posts
<div class='quotetop'>QUOTE (snopro joe* @ Jan 22 2007, 08:52 PM) <{POST_SNAPBACK}></div>
i changed springs on my 6 tower primary clutch, 03 440 firecat last wknd, took it for a test ride, and now its sticking shut, when its completly shifted out, and wont snap back to downshift unless i hit a bump or hit it with a rubber hammer!and it worked fine before i changed springs, and the cover is on right, i checked for cracks and saw none, whats the problem???[/b]
DID YOU USE AN AFTERMARKET SPRING? IT'S WIDER THAN AN AC SPRING, PROBABLY GRABBING ON THE SIDES. MAY NEED TO RELEVE IT A LITTLE BIT WHERE IT'S RUBBING. :thumbsup:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top