Arctic Cat Forum banner

1 - 6 of 6 Posts

Registered
Joined
57 Posts
Discussion Starter #1
Little info on what happened. I picked up a 07 trv 650h1. Would only start with recoil as crank case was broken where starter gears go. It would fire right up in a couple pulls and run and drive fine. I took out battery and stator and got a guy to weld and build up crankcase. Got back reassemble and no spark. Took this cdi off and tried on another 650h1 and that one fired right up. I then tried another cdi and now I have spark, it runs and drives excellent but the pod reads E in neutral and reverse.
I've checked all connections, fuses, diode, grounds.
Just doesn't make sense to me that the cdi works on another bike and not this one, then can run with different cdi just read error code. The shifting linkage is lined up as well as the dots on the gears. Any advice out there please tell me where to go next. Thanks 馃槉
 

Administrator
Joined
37,681 Posts
Did he weld it with the cdi in it ? Battery hooked up?
 

Registered
Joined
57 Posts
Discussion Starter #3
CDI was left plugged in yes, but the battery and stator were not even in the bike.
 

Registered
Joined
182 Posts
Plug it back in and make sure all pins are intact and not bent

Sent from my SM-G950W using Tapatalk
 

Registered
Joined
57 Posts
Discussion Starter #6
Thanks for the reply, Sorry been away for a bit. I checked all pins, cleaned throughly and reconnected. Same thing.
 
1 - 6 of 6 Posts
Top