2007 Arctic Cat 500 Manual Vacuum lines

231 Views 1 Reply 2 Participants Last post by doorfx, 4 d ago

chall8974

Discussion Starter · 4 d ago

Trying to rebuild a bike, there is a small clear vacuum line going up to the pod with a Y fitting and what appears to be a check valve. most of the lines were dry rotted and missing so i am trying to figure out where this goes and what attaches to it. I cannot find a good diagram anywhere. Thanks

Save

1 - 2 of 2 Posts

doorfx

· #2 · 4 d ago

It doesn’t connect to anything. Should not be a tee. It’s an atmospheric pressure line. Just needs to be higher than the carb

2013 700 XT TRV EPS :
28" Bighorns on bed linered 08 Prowler rims , Wireless winch remote, 3000LB. Warn winch, Heated front and rear grips, Cat relay wiring harness for accessories, LED light bar, 08 650 trv LTD rear box, Heated rear seat, Elka stage 3 shocks all 4 corners, Aftermarket A-arm bushings, aftermarket sway bar bushings(prototype), Deluxe brush guard bumpers front and rear, Red anodized Hause fairlead, beverage opener winch hook, Synthetic winch rope, RTR motor mount bushings, Dynojet PC5 programmer, Dynojet Autotune, [/B]

07 500 Gone but not forgotten;
Dynojet/142m/45p/3rd/3turns--Clipped and drilled--Unifilter--Easy adjust PMS--L.C.V. mod--AC Swaybar--Exhaust mod--2"Snorkels--Sanny shock bushings-- Airdam stage 1--PSC phase 2--21/ 23gr rollers--Dalton yellow spring--.7mm shim--Sanny Steerlites--RTR Flex Bracket--2 up seat / pegs--Tach--AC handguards--28" Outlaw mst's--Skull tailight--Skull shifter--Self Resetting Breakers--1" Wheel spacers--Customcncparts Steering Damper--AC deluxe handwarmers--6000k HID'S hi/lo--AC Deluxe Bumpers--Inline Fuel Filter-- O2 sensor \AFR guage--Black Magic Full Stainless Exhaust System--Wireless Winch Remote--29.5 Outlaws--Fox Podium X Rear Shocks--

It's mind over matter,If you don't mind,
It just doesn't matterCat happy

No Boost No Bottle
just balls and throttle

Save

1 - 2 of 2 Posts

Top Contributors this Month