2006 Artic Cat Prowler Won’t Start
1 - 2 of 2 Posts
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
2009 700 H1 Stuck throttle
Utility ATV repair, maintenance, troubleshootingBackground, 2 years ago throttle stuck, I took the atv to Basspro and they said that my throttle body had seized and needed replacing to the tune of $700. Fast forward to present, I went to run the atv and the throttle was stuck again. I removed the throttle body, stripped everything off of it...- 0
- 18
-
2018 mud pro 700
Utility ATV repair, maintenance, troubleshootingHey I have the mud pro. I notice belt shavings coming out snorkel. So I opened up clutch cover and my belt is rubbing. The belts sits quite a bit higher over the top of secondary. How would I go about getting my belt to sit I’d say 1 cm or so lower to at least flush with secondary.- 2
- 27
-
Mudpro2018 · updated
-
07 400 4x4 Manuel running issues
Utility ATV repair, maintenance, troubleshootingOkay I’m new to the page but I have a 2007 artic cat 400 Manuel 4x4 I got it used and it ran great when I got it but I took it riding and had no issues until it cut off when my buddie got stuck. It refused to start so we pulled it back. After we got it back it started and ran like normal then...- 4
- 62
-
650 H1 Ignition switch problem
Utility ATV repair, maintenance, troubleshootingHere's my situation 2008 650 H1... key in ignition switched to on - everything's good (pod display, engine start button fires right up) things are normal. Now turn key to "lights" and engine shuts off, pod display goes blank (nothing, not even the red background) BUT the lights are on and...- 1
- 45
-
banjo fitting size?
Utility ATV repair, maintenance, troubleshootingcan anyone tell me the size of the banjo fitting on the 2005 arctic cat 400 4x4 with rear independent suspension? need to make a new longer line.- 2
- 71
Join now to ask and comment!