Arctic Cat Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
. I'm trying to get inner chain case out so I can replace that bolt That holds the reverse shaft in place. I believe that I have removed all the bolts but both drive and driven bearings are still in I was hoping just to pry out the case and replace that bolt. the chain case does not move I have all the bolts out for the gears and the brake assemble has been removed. The bearing plates are out but the chain case wont move. do I have to remove the bearings I was hoping to slide it out and back in again without having to disassemble any further.
 

·
Registered
Joined
·
10,129 Posts
I think you're just fighting with the two bearings holding it. Remove them completely as you have the retainers off anyways.
 
1 - 2 of 2 Posts
Top