Arctic Chat : Arctic Cat Forum banner
1 - 3 of 3 Posts

·
Registered
Arctic Cat Zr900
Joined
·
3 Posts
Discussion Starter · #1 ·
Hey guys, I have a 03 ZR 900 that i recently replaced the jack shaft on. So I had to obviously take the secondary off, all the gears in the chain case and the top bearing inside the chain case. After about an hour of trying to get the jack shaft out (holy rust!) I’m finally ready to reassemble everything. But I don’t know how tight everything should be. Does anyone know what the torque specifications are ? Reason why I had to replace the jack shaft is because the retaining nut ended up backing off the shaft and stripping everything.
365143
 

·
Registered
Joined
·
13,979 Posts
Download a free service manual from Country Cat. Top of home page under technical information
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top