Arctic Cat Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have a 2002 Arctic Catt 500 ATV. The rear drive boot is torn and needs replacing. I have removed the rear output assembly, and now need to remove the seal plate in order to get to the snap ring that holds the bearing assembly in so I can put on the boot. How to you get the seal plate off to get to the snap ring? Is the seal plate reusable?
 

·
Registered
Joined
·
10,736 Posts
I had to do that boot on a 2003 400 ACT three years ago. I can’t remember exactly how I got it out but I did reuse the seal. The outer edge was a little rough after so I did use some RTV sealant on it to make sure it sealed.
 
1 - 3 of 3 Posts
Top