Did you install an imitation voltage regulator or an Original Equipment 0630-001?Hey all my name is Dave. I am chasing a sled gremlin to no avail and have exhhuasted everything I can think and read to no avail so I thought I would hit the knowledge base.
The first thing I would like to find if possible is the wiring diagrams. Is my only option to buy a manual? I used to have such luck in the past with finding them online.
So my issue is not an uncommon one, however the causes can be vast. Often I my sled will bog and not get up to clutch engagement RPM I also have been toasting my head and tail light.
I have extensively cleaned and recleaned the carbs, synced the carbs, I have replaced the voltage regulator, I have ohmed out the stator and tested the voltage which all seem to be in acceptable range, I have gone over and over the harness and even rewired parts of it that pass though with the cooling lines. checked and regapped plugs, spark looks bright, when I do the bypass at the four prong plug from the stator I have same result. I think that most of it.
Any more ideas, diagrams**, advice would be hugely appreciated. I love this sled and want to fix it.
I also have one other question for the experts, when I remove the plug for the voltage regulator I get continuity to groud from both the yellow and the brown wire... This does not seem right at all. I i check it at the stator I get nothing shorted to ground.
I know this is a book, just want to be through so I am not wasting too much time.
Thanks for reading.
P.S. can the stator possible create a short to ground bypassing my regulator when its hot and fry my lamps??
1994 ZR580 Carbed NEED HELP
Hey all my name is Dave. I am chasing a sled gremlin to no avail and have exhhuasted everything I can think and read to no avail so I thought I would hit the knowledge base.
The first thing I would like to find if possible is the wiring diagrams. Is my only option to buy a manual? I used to have such luck in the past with finding them online.
So my issue is not an uncommon one, however the causes can be vast. Often I my sled will bog and not get up to clutch engagement RPM I also have been toasting my head and tail light.
I have extensively cleaned and recleaned the carbs, synced the carbs, I have replaced the voltage regulator, I have ohmed out the stator and tested the voltage which all seem to be in acceptable range, I have gone over and over the harness and even rewired parts of it that pass though with the cooling lines. checked and regapped plugs, spark looks bright, when I do the bypass at the four prong plug from the stator I have same result. I think that most of it.
Any more ideas, diagrams**, advice would be hugely appreciated. I love this sled and want to fix it.
I also have one other question for the experts, when I remove the plug for the voltage regulator I get continuity to groud from both the yellow and the brown wire... This does not seem right at all. I i check it at the stator I get nothing shorted to ground.
I know this is a book, just want to be through so I am not wasting too much time.
Thanks for reading.
P.S. can the stator possible create a short to ground bypassing my regulator when its hot and fry my lamps??
The first thing I would like to find if possible is the wiring diagrams. Is my only option to buy a manual? I used to have such luck in the past with finding them online.
So my issue is not an uncommon one, however the causes can be vast. Often I my sled will bog and not get up to clutch engagement RPM I also have been toasting my head and tail light.
I have extensively cleaned and recleaned the carbs, synced the carbs, I have replaced the voltage regulator, I have ohmed out the stator and tested the voltage which all seem to be in acceptable range, I have gone over and over the harness and even rewired parts of it that pass though with the cooling lines. checked and regapped plugs, spark looks bright, when I do the bypass at the four prong plug from the stator I have same result. I think that most of it.
Any more ideas, diagrams**, advice would be hugely appreciated. I love this sled and want to fix it.
I also have one other question for the experts, when I remove the plug for the voltage regulator I get continuity to groud from both the yellow and the brown wire... This does not seem right at all. I i check it at the stator I get nothing shorted to ground.
I know this is a book, just want to be through so I am not wasting too much time.
Thanks for reading.
P.S. can the stator possible create a short to ground bypassing my regulator when its hot and fry my lamps??
1 - 7 of 27 Posts
Did you install an imitation voltage regulator or an Original Equipment 0630-001?
Yes, You should have a high resistance reading [ground] on both wires. If you do not, you would have an open circuit, current would not flow. Picture this, You have a light bulb, you disconnect the battery for testing. You hook up an Ohm meter- one lead to ground, the other lead to the Positive side of bulb- you would show a resistance [ of the bulb filament] to ground. If you do not, you have an open circuit [blown bulb filament].It was imitation. However the lack of RPM problem (bogging) also occurs when I bypass the regulator. It is possible I have TWO simultaneous problems, but I am still trying to determine if I should have continuity to ground from both wires going to the regulator on the wiring harness side?
Well, even with the bulbs out, you still have loads [grip warmers, etc] and then their is the stator itself. If you feel you have a 12v shorted to ground, you would have to remove ALL loads. If you had a short [12v to ground], you would most likely have blown fuses, melted wires , and smoke. Nothing you have said indicates you do. at least at this point.
May be difficult finding a service manual with a wiring diagram due to the age of sled, that's what you really need. Problems like this are often beyond the realm of what forums can do, unfortunatly. Just keep us informed of your testing and the results, and we will try to do the best we can.
I'm wondering, to rule out a 12volt short to ground if you insist you have one, is to power up all your accessories [bulbs, heated hand grips,etc.] with a battery and hooked up with a fuse [in case you do have a short, fuse will blow instead of wires smoking], with the sled engine OFF. If you can power up your accessories with a fused 12 volt battery with the sled engine off, that would rule out a short. Just like turning on your key on your car to get the lights to come on-engine off. Just thinking out loud here....
May be difficult finding a service manual with a wiring diagram due to the age of sled, that's what you really need. Problems like this are often beyond the realm of what forums can do, unfortunatly. Just keep us informed of your testing and the results, and we will try to do the best we can.
I'm wondering, to rule out a 12volt short to ground if you insist you have one, is to power up all your accessories [bulbs, heated hand grips,etc.] with a battery and hooked up with a fuse [in case you do have a short, fuse will blow instead of wires smoking], with the sled engine OFF. If you can power up your accessories with a fused 12 volt battery with the sled engine off, that would rule out a short. Just like turning on your key on your car to get the lights to come on-engine off. Just thinking out loud here....
Put the track up and run it at 4,000 rpm with a voltmeter on it. Then check for peak voltage.So I could not get a fuse to blow, nor could I get the voltage to spike while connected to the multi meter. It is solid at right around 12v. I am still at a total loss.
No, everything hooked up. Arctic Cat says [for my '99 Pantera] any yellow wire [accessory power wire] should do. 11-13 volts AC.Should I check it right from the stator, with regulator unplugged?
Did you buy an Arctic Cat OE stator, used, or an imitation one?Okay, I have decided to go with my gut and replace the stator. It should be here this week.
Make sure you keep your old stator. You can have statorkev rewind it for you. When the imitation one goes bad, you can use your rewound one. I am on my 3rd season with statorkev's rewind.I went with one from EBay from sledpartsguy. Not OE
By the way, are you replacing stator for an overcharging problem?
1 - 7 of 27 Posts
Arctic Chat : Arctic Cat Forum
Arctic Chat Forum is a community to discuss Arctic Cat 400, 440, 500, 650, snowmobiles, sleds, ATV's and more. Join the fun!
Full Forum Listing
Recommended Communities
