Arctic Chat : Arctic Cat Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Hey everyone, i have a 94 ext 580 and i recently acquired a fully rebuilt rear skid for a 1997 zl440, when i went to swap the skid into the ext, for the life of me i can not get anything to line up. The adjusters are all the way in and i cant get the rear holes to reach a hole on the plate. Please help. And no, it is not a ett tsl. Just a ett
 

·
Registered
Joined
·
4,135 Posts
The ZL skid will have the mounting points closer together than the old skid. If you can find a 97 ZL sled you can measure the distance between the mounting points and get the location to to drill a new hole. The TSL skid I swapped into my 94 was from a 97 ZL. I used the same front hole and drilled a new hole for the rear tunnel mount. Don't remember for sure, but it was about 1 1/2" forward of the original location.
 
1 - 2 of 2 Posts
Top