Arctic Chat : Arctic Cat Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
So I recently acquired a 93' Lynx mountain cat 340 and it had no spark when I got it, but I bypassed the TSS and KILL switch now there is spark and the snowmobile idles fine, but when I start to accelerate it bogs the snowmobile will move a bit then bog and eventually die, then it will be difficult to start again??? any guess'??
 

·
Premium Member
Joined
·
701 Posts
Clean carb. Probably full of gunk!
Set choke.
Set up carb(slide).
This should get running, Then
Clean and check clutches. prim & sec.
 
  • Like
Reactions: tr1cknyn3

·
Registered
Joined
·
18 Posts
Discussion Starter #3
I cleaned the carb already, not sure its the right carb though, this carb has 2 extra ******* on it? i thought one would be for the primer so i hooked up the line but it just squirts out the other nipple, what setting should i set the throttle at there is like 6 settings? and how do i set the choke??
 

·
Premium Member
Joined
·
701 Posts
thumbguythumbguythumbguy
 

·
Registered
Joined
·
5 Posts
do u mix your gas or is the oil system still hooked up because if it is not being use then thats what the 2 ******* are for
 
1 - 6 of 6 Posts
Top