Arctic Cat Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter #1
Looking to find 12vdc at the ignition switch. This a 02 zl550esr. I want to run a water temp gauge but not wired diectly to the battery, so the battery does not run down. Any and all replies will be much appreciated.
 

·
Registered
Joined
·
1,778 Posts
The should be a blank spot on the ignition switch (A). If you attach a voltmeter between it and ground you should see 12V with the ignition switch on and 0 with it off.

The attached diagram should be close enough to what you have
[attachment=139801:pages_from_Sect6.pdf]
 

Attachments

·
Registered
Joined
·
34 Posts
Discussion Starter #4
Wayne, thanks a ton. This is the same conclusion I came to last night after looking at the electrical diagram. I tested every wire on the ignition yesterday, except that one,duh! I knew there had to be a switched 12vdc but was just struggling to find it. Thanks again, and I really appreciate your reply.
 
1 - 4 of 4 Posts
Top