Arctic Cat Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
So I'm trying to adjust the valves on the 07 jaguar z1000 I can not find the correct measurements anywhere online can someone help me out pls? And I have the motor tdc on the crank mark. Am I able to adjust all the valves or is there two Mark's to adjust both sides? Maybee I just have one cylinder that is that far out on measurements.. but I can fit the feeler guage in the starter side but not the crank side on exhaust side
 

·
Administrator
Joined
·
2,253 Posts
Don't take this the wrong way, but it seems you are over your head.
You can only measure the cylinder that is on TDC of the compression stroke.
On the exhaust valves you have to be sure the auto decompression device isn't opening the valve, adn that you aren't trying to measure where it is.
Any adjustment requires removal of both camshafts, and the timing chain tensioner.

EDIT I'll move this thread from the New Member Introduction Only!!!! section to the appropriate section..
 
1 - 2 of 2 Posts
Top