Arctic Chat : Arctic Cat Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hey everyone,

I bought an 04 f7 this summer only to find out it had been patched together long enough to run 30 miles.
Well into the top end rebuild now and have a feeling the head has been planed. Does anyone know what the head thickness is supposed to be? I'm going to go measure mine and then compare.

Any help would be greatly appreciated!
 

·
Registered
Joined
·
6 Posts
Ed
Not sure this will help, but I have the head off my 04 S/C 600. Measured the head and it measured 32mm or 1.27in at the thickest point. Good luck.
 

·
Banned
Joined
·
1,129 Posts
when you put the motor together, do a squish test. You should be in the range of 0.59-.078. If you are less then .059 verrry important to run 91 or better.

Most F7s are in the 0.065 area
 
1 - 5 of 5 Posts
Top