Arctic Chat : Arctic Cat Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
69 Posts
I had the same thing happen to me last year the sensor is on the right hand side of the oil reservoir (while facing the sled) you’ll have to suck the oil out of the tank and remove the exhaust. The sensor just pops off it works like a gas gauge a float on a twisted piece of metal if. I found that mine was sticking a bit. I just cleaned it so that it would move freely again, also clean where the actual sensor slides into the top of the hole unit (you’ll see when you take it apart) and then checked it with a multimeter to make sure it was working then popped it back on and has been fine since hope this helps
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top