Arctic Chat : Arctic Cat Forum banner
1 - 4 of 4 Posts

183 Posts
Discussion Starter · #1 ·
I know this has been "beaten" to death and I read tons of posts, and so far this is what I've done.
-Broken power valve cables, cleaned valves,replaced and adjusted
-disconnected TSS
-tested stator, all numbers within parimeters
-put 12v to fuel pump, lots of fuel
-unplugged the ethanol wire
The sled just dies(stumbles) when I pin it off the line.
What should I be looking at next? and id there a test to see if the injectors are bad?
Cheers Ray
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.