Arctic Chat : Arctic Cat Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 7 Results
  1. General ATV Discussion
    So we are rebuilding the top end on an Artic Cat 650 VTwin 2005 . We have defiantly noticed the lack of OEM parts for this particular ATV. My question is, can we use valves for a Brute Force 650 because they both have a Kawasaki motor in them, same year model and all that.
  2. General ATV Discussion
    Hey guys I have a 2005 arctic cat 250 and it takes about 3 minutes to start and it blows air out of carb and if you drive it for 15 mins it will idle and run perfect the other problem I have is if u press the throttle in first gear like to pop a wheelie the powers delayed. I’m thinking it’s...
  3. General ATV Discussion
    Hello, I ride a 2019 Alterra 450 (500 in the US/CAN) with 3500 km on it now. The service manual advices to check and to adjust the valves clearence after the running-in period (first 500km) and then each 6000 km: 0,10mm at admission and 0,15mm at the exhaust. Does the valves clearence really...
  4. Utility ATV repair, maintenance, troubleshooting
    Well, my 300 4x4 has smoked when I start it since I bought it this spring... I knew then that this would be a winter project. I just tore the top end off tonight and the damage looks significantly worse than I was imagining. It appears to me that the cam chain was wearing along the sides of...
  5. Utility ATV repair, maintenance, troubleshooting
    I'm a proud new owner of a "running project" 2005 AC 650v2. I purchased this atv from a guy who claimed it had an oil leak and needed new rings. seemed simple enough. She runs with plenty of power and without smoking but noticed oil out of the air box and there was a hell of a lot of noise...
  6. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    i was told today that it may be beneficial to clean my power valves. i got the new gasket and had a general idea of what had to be done. i took out the valves cleaned off all the carbon and then cleaned it with brake cleaner. i oiled them with my injection oil before reinstalling them. i put...
1-6 of 7 Results
Top