Search Results for ‘sno pro’

Hey there, I have recently bought a 2005 sno pro 440 with a 600 motor in it. The guy said it’s a sno pro 600 motor, but wasn’t sure the year. I was just wondering if any of you guys would know what year of motor it is or where I could find out the year of it. The tag on the motor says k60- 100030

Hi guys I’ve been doing some routine maintenance on my sled before the season starts and I’ve noticed when pulling it in and out of the garage on warmer days. I get a weird exhaust sound while pulling in. It almost sounds like it gets louder for a split second then returns to normal. It has a...

2011 sno pro f800h.o. front shocks are not available. Where do I find new ones I want to switch them to coil overs also. And where can I get the rear shocks redone at? Any help would be greatly appreciated thank you

I have a 97 ZR 440 that I cant seem to find carbs for so I have put a set of 2000 ZR440 carbs in......what Jetting should I run.....same jets as what are in the 97 carbs or do I have to do something different....new to working on carbs......I got it to run but runs horrible.....

I have what I believe is a 97 ZR440 with the aluminum ETT tunnel that I would like to swap a ZR700 into......just looking for information on the swap or if its even possible.....from what I can see they use different mounts....hoping someone may know what I need or someone has already done the...

I have a 96 ZR440 chassis and a 94 ZR580 EFI with a bad bulk head but a fresh motor.....how hard would it be to swap the 580 into the 440 and what all would I need.....getting information before I try tearing into either sled

I have an 04 F7 EFI / swapped 05 440 Sno Pro Mod and just found out there's an ethanol switch on it. It's not stock to either sled and my issue right now is that the switch is sideways with no label and I have no idea which way is regular or ethanol or how to figure it out. Can anyone help...

I am looking into getting a 2010 Sno Pro 600 but am not sure if I am able to convert the sled to run on pump gas as it is a lot more convenient for the riding I will be doing. If this is possible what is needed to be done? I am aware there would be a power difference but I am not super concerned...

I have an F7 efi swapped 05 AC 440 Sno Pro Race chassis and want to make it into more of a trail/powder sled. I've been trying to find a longer track for it but haven't had any luck. Does anyone know where I can get one, or if I can use a track from another sled? I've seen people talk about...

I have an F7 efi swapped 05 AC 440 Sno Pro Race chassis and want to make it into more of a trail/powder sled. I've been trying to find a longer track for it but haven't had any luck. Does anyone know where I can get one, or if I can use a track from another sled? I've seen people talk about...

I just bought a snowmobile with an 04 F7 EFI engine in a 440 Sno Pro chassis. The shop I bought it from didn't have the chassis info(year, trim, etc), but I did some research and it looks to me like it's an 05 Arctic Cat 440 Sno Pro l/c (racing model) shown in the last picture. Can anyone...

I just bought a snowmobile with an 04 F7 EFI engine in a 440 Sno Pro chassis. The shop I bought it from didn't have the chassis info(year, trim, etc), but I did some research and it looks to me like it's an 05 Arctic Cat 440 Sno Pro l/c (racing model) shown in the last picture. Can anyone...

I just bought a snowmobile with an 04 F7 EFI engine in a 440 Sno Pro chassis. The shop I bought it from didn't have the chassis info(year, trim, etc), but I did some research and it looks to me like it's an 05 Arctic Cat 440 Sno Pro l/c (racing model) shown in the last picture. Can anyone...

I just recently purchased a 2009 Arctic Cat Crossfire R8 Sno Pro and I need a new drive shaft cog but I was wondering if any other Arctic Cat models or Crossfire years would work for the part that I am looking for.

Hey guys, finally got some snow here in Ohio, took my sno pro out today and it ran fine for about 15 minutes and then bogged way down and losing power, starts on the first or second pull every time but it seems like when it gets warm is when it starts ****ting the bed. Any idea on what could be...

I have cooked me ecu on my 2012 sno pro 600. I am in the market for a used one that will work for my sled. My question is what years are compatible to plug in and work? and is there any way to cross reference numbers on them?. I dont mind needing to reflash the new/used one I find. Thank you...

Hey all! Just purchased a 2012 pro cross 800 and am stumped cannot figure out why it won’t just idle normally, as soon as I hit the throttle and rev it up it’ll usally idle down to 2300-2500 and then some times down to normal range , throttle cables got slack so I know it’s not that if anyone...

Anyone have any pictures or information on where to drill the holes in the tank to mount the fuel pump? I Already swapped the motor and wiring, now I'm stumped on where to mount the fuel pump. Any help would be appreciated. thanks!

Hey guys, new member here..tuning up the sled for the winter, started in 2 pulls (fresh plugs, gas) and took it around the yard for about 5 minutes, noticed that it started losing power and wanted to die. Could this be a carb problem? cleaned them out last year before storing it, out of sync...

I purchased a 2007 cfr1000 sno pro last season and all was good for about three days, had it out around the house in the fields and then it quit. Threw code for the apv valves so replaced cables and cleaned them up. It seemed to fix the problem until the sled quit after about 40-50km or riding...