Arctic Chat : Arctic Cat Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 14 Results
  1. General ATV Discussion
    I am looking for a pipe for my 2013 arctic cat 500 , if anybody knows where I can find one it would be greatly appreciated, thanks
  2. M Series/Mountain Cat Pre 2011
    hey i took off my pipe and re painted it, but i put it back on with out the silver heat shield.. will that cause problems on the trail? will it affect anything that i might lose power on?I dunno or is it just for looks?
  3. M Series/Mountain Cat Pre 2011
    What is the best pipe for my 2010 m8 hcr? as in horsepower torque and weight loss?
  4. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    I have an 01 zr 800 with stuff like d&d power breather and a black magic single pipe and can, the problem is that the d&d clutch kit in my sled is for twin pipes (I think) previous owner took the twin pipes off and put the bm single (didn't like finnicky twins) but he never clutched it for the...
  5. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    I just bought a barely used D&Dpipe and chip for my Powder Special and which it says must run 91 or higher octane but it also says "If fuel with ethanol is used Ethanol chip must be used to prevent engine damage/failure." So my question is this the wire on the ECU you plug/unplug for ethanol and...
  6. M Series/Mountain Cat Pre 2011
    I have a chance to buy a used Black magic Pipe for 150 bucks and Can for 150 bucks, For my 02 EFI 800 and I was wondering if there is anything I had to do for it. Or can I just put it on and go. I figured I should buy it, because it shouldnt be hard to get my money back. But can anyone help? Thanks
  7. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    I am looking for a y pipe for a 1999 zr 700. also curious. the flanges on mine that bolt up to the engine run str8 across. as they should because this is the only way they will bolt up to a twin 700. However when i look the part up for order the diagram shows that the flanges are slanted. is...
  8. Utility Performance / Technical info
    I am just wondering if anyone with an hmf pipe on a mudpro has had any problems or had to do anything to the bike to make it work right.
  9. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    I have a '94 580 zr (carb), it bogs down on take off, it is really snappy when it is moving, I have heard these sleds have less low end torque, than others, could a person, switch jets, clutch weights to help, or maybe fined a pipe for it? Any ideas would be great.
  10. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    ok here it goes. i have a 99 powder special 600 EFI with D&D pipe and chip and also the PAC. i got the pipe and chip with the clutchkit a couple years ago and installed them but didnt ride at all last year. went out today and got the fuel adjusted via PAC. runs good, has awesome power (for a 600...
1-10 of 14 Results
Top