Arctic Chat : Arctic Cat Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 10 Results
  1. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    Trying to replace all 4 drive bearings in my 2006 z570lx. When reassembling I could not remember or figure out where the v ring seal for the chain case goes on the driveshaft. I have a service manual but it mentions nothing about a seal and one definitely came off of the sled when disassembled...
  2. Panther/Pantera/T570/Touring
    Hey! First post, so hello! :) Today I picked up a ‘96 Arctic Cat pantera. It said it needed work to it. I come from working on big engines, so I figured here would be my chance to take a shot at identifying this issue. I’ve been googling and (it seems that) driveshaft bearings are under the...
  3. F/M/XF/ZR Procross Chassis 2012+
    I tried searching be couldn't find it sorry. I've got a 15 High Country 800, I need to do the driveshaft seal/bearing. Can it be done without removing the whole chaincase from the sled? Any tricks? I'll be doing the other side as well, any tricks to doing the one in the brake caliper? And info...
  4. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    Got my new bearings for my jackshaft and driveshaft. Im putting my jackshaft back in and i wanted to know if i needed to grease or pack grease into the clutch side bearing. If i do should i use low temp grease or wheel bearing grease? Both bearings on the right side dont need grease because they...
  5. General ATV Discussion
    I was trying to remove my drive shaft to replace the seal and I unbolted differential pulled axles moved it forward about a inch and the driveshaft won't come off no matter what I try. What am I doing wrong here? Any advice on how to get the driveshaft out? I also unbolted the two bolts that...
  6. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    Finally got the driveshaft out, I checked the bearings and they sound kinda crusty, so im going to replace them. The one bearing on the chaincase side sliped off eazy but has a weird irregular groove in it i wanted to know if this is normal or not. And ive been trying to get the lock collar off...
  7. DVX/LTZ400/KFX400
    I am so frustrated :angry:with my kids wheeler. He has a 2002 90cc that has broke three drive shafts. It's like the chain pops off and wraps around the rear sprocket and breaks off the shaft from the tranny. The chain was properly tensioned all three times. Maybe it is something else causing...
  8. Utility Performance / Technical info
    I got a 2012 mudpro 700 and today i was riding and i broke my front drive shaft unerversial. I noticed before that my engine had ALOT of movement on the clutch side when accelerating. I no they are rubber mounts but im wondering if that woulda caused missalignment and cause the unerversial to...
  9. Utility Performance / Technical info
    I have an arctic cat 400 auto, when I slow down in reverse or turn sometimes it popss and annoys me. I think its the driveshaft, but I'm not sure. If it is what goes bad in them to make it do this? Bearings? Also my front left brake is dragging and I can't fix it. Should I try bleeding it? I'm...
1-9 of 10 Results
Top