Arctic Chat : Arctic Cat Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Utility ATV repair, maintenance, troubleshooting
    The rear drive/propeller shaft on our 2005 Arctic Cat 400 ATV needs to be replaced because the splines wore down. I've obtained the new shaft, boot, clamps, etc. (see highlights in picture below), but in the service manual, I can't find any mention about the boot replacement. Does there need to...
  2. Arctic Cat Snowmobiles
    I saw a post from 2010 (sierra5) had the exact same issue as me. Broken Drive Shaft on the exact same year, make and model. Seems like there was an issue with these (maybe why they are so hard to find) I am going to attempt to remove the broken shaft myself, take the broken parts and the new...
  3. Firecat/Sabercat
    I have a 03 f7 and we recently put in drive cog bearings, and I noticed that the magnet was all chewed up. I didn't think anything of it until it was back in and the speedometer didn't work. I.noticed you can buy the magnet seperate at arcticcatpartshouse.com. how do you put it in? Is it glued...
  4. CrossFire/CF/CFR 06-11
    A few weekends ago the bearings at the brake side broke. So i bought new bearings, and dissasembled most of the snowmobile. But here's the problem, the drive shaft is now stuck to the diamond drive. Do anybody here got any advise how to get the shaft to part from the diamond drive? I have tried...
  5. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    Hey guys just tore my sled down 2001 ZR 800 w/ 883 preditor kit. to replace the drive shaft bearing clutch side was so bad the old locking collar and what was left of the bearing were ceased on so I had to take the whole shaft out to get it off (effing never again) anyway now that I'm all set to...
1-5 of 5 Results
Top