Arctic Chat : Arctic Cat Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 15 Results
  1. Arctic Cat News
    Was wondering if anyone had a fuel map for a boondocker set up on a 2002 Mountain Cat 800 EFI with twin D&D pipes. I just got a boondocker and D&D just said they dont have the map anymore for this sled. All help would be much appreciated.
  2. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    I would like to put an aftermarket can on my 2001 ZL600EFI so it sounds a little better. Can anyone make any recommendations? I was thinking D&D... Can anyone direct me to where I would be able to purchase one? Thank you!!!
  3. Firecat/Sabercat
    What i already have done to my f5: -Graphics kit -New bearings -bar riser -handgaurds (sportech) -Grip rails What i am looking to do: -Can/scilencer. i really need help and information, what is the best one and most quiet -seat -any other sugestions The sled is an 03 f5snopro. please give me...
  4. Firecat/Sabercat
    hey just trying to get my clutching on my 05 f7 adjusted right where i want it. right now everything on it is bone stock except for a one of those little d&d speed shifters on the 2ndary and some different springs. it will have new vforce3 reeds in it mid-week. i don't know how that will affect...
  5. Sled Mods & Tech-Tips
    Hey guys! I just bought a D&D y- pipe for my 2005 F7 and was wondering if anyone else has put one on and noticed a really big difference or not? Everything is stock except for a shift assist and a bigger air intake
  6. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    I just bought a barely used D&Dpipe and chip for my Powder Special and which it says must run 91 or higher octane but it also says "If fuel with ethanol is used Ethanol chip must be used to prevent engine damage/failure." So my question is this the wire on the ECU you plug/unplug for ethanol and...
  7. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    ok here it goes. i have a 99 powder special 600 EFI with D&D pipe and chip and also the PAC. i got the pipe and chip with the clutchkit a couple years ago and installed them but didnt ride at all last year. went out today and got the fuel adjusted via PAC. runs good, has awesome power (for a 600...
  8. General Snowmobile Discussion
    Just picked up this sled and it was missing the primary clutch. Have a 9 tower artco 30mm donor. Motor was dynoed and peaked at around 8450. Need to know where to start with spring/weight combo.
  9. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    hi i just bought a D&D clutch kit for my 2004 zr 900.. i have got a good understanding on how to install the kit, but just wanted to see if there was anything to change. like setting up my rpm? should i have to do that? any inputs would help! thanks
  10. Sled Mods & Tech-Tips
    I have a 98 ZR 600 EFI with the D&D chip, pipe, and clutch combo. I have it extended to a 136" with a 1.5" ripsaw track and I am having some clutch issues. When doing this I did to switch to an 8 tooth driver essentially gearing it down pretty significantly. If I pin it from a stop it really...
  11. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    Well I got my D&D pipe along with the Boyesen power reeds installed last night. I've read quite a bit about rejetting after the addition of a pipe. However, the reed package said they will cause your sled to run rich and the pipe would cause your sled to run lean. So my basic question is...
1-11 of 15 Results
Top