Arctic Chat : Arctic Cat Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 13 Results
  1. F/M/XF/ZR Procross Chassis 2012+
    I purchased the ZR used last spring. Poor winter here in Michigan not much riding. I have ran it about 250 miles since purchase. The sled has 4800 miles on it. This past summer installed CVTech primary clutch also went through everything and replaced, cleaned or adjusted. Felt sled ready to go...
  2. F/M/XF/ZR Procross Chassis 2012+
    Howdy all, Got myself in a pickle here. I have a trip planned for tomorrow and the chances of making it are looking slim. Blew a top end last weekend on PTO side. The looks of the piston appear it overheated and/or cold seize. It has 4 scuffs with even distance from each other. There is even...
  3. Panther/Pantera/T570/Touring
    Hello all, I'm new to the forum hoping to find a little help. I believe I'm in the correct thread but please suggest if it should be moved. Thanks! The Sled - 2002 panther 570 fanner I'll start by saying that I am by no means a sled expert or a 2-stroke expert but I have done a fair amount of...
  4. Proclimb M/Ascender/Alpha One 2012+
    I live in Colorado and usually have deep snow to ride. Bought a 2020 alpha hardcore and it still bogs on deep days no matter what Ive done. Dealer acts like theres nothing wrong. Ive added a can and better venting, which has helped the issue. Still happens on these deep days we get though...
  5. Utility ATV repair, maintenance, troubleshooting
    I'm a long time viewer first time poster, I have a 2006 400 4x4 auto quad that has been sitting for about 8 months. It started up just fine and I rode it around a bit. Then I left it overnight and started it up again and it idled just fine. As soon as I put it in gear it started to bog down once...
  6. CrossFire/CF/CFR 06-11
    newbie any advice for searching specific problems
  7. M Series/Mountain Cat Pre 2011
    my 05 m7 hasnt ran right since i got it. it has a big loss of power in the bottom end and studders throughout like it doesnt want to go into the top end. once there, it runs perfect and has great power. this is at 1000 ft. i went to cooke last spring and the studdering was gone but the power was...
  8. M Series/Mountain Cat Pre 2011
    I have a 2002 arctic cat mountain cat 800 carb with about 2500 miles. And I was wondering why everytime i start her up after sitting for a while (like a day or more) she has a really bad bog at high Rpms and it doesn't go away till I scream it out. Like gun it till the rpms finally go up and...
  9. M Series/Mountain Cat Pre 2011
    Hey, I have a 2002 mountain cat 800 that i'v been getting a bad bog. the bog is bad when i try to pin it. I had always been putting 87 octane gas in it untill this weekend when i put 91 octane in it. I also had just switched over to using the APV oil. The bog started right after this. would...
  10. M Series/Mountain Cat Pre 2011
    Just recently my M6 is studdering off the line. Here are the things I know are correct or have checked: Belt rides 1/16" above secondary Air induction plenum is sealed as best as it can be (not snuffing in snow)(Frogskins on the upper triangle ports and Frogskin on upper inside now, under the...
  11. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    I recently purchased a brand new, mint 1999 Arctic Cat Z.R. 500 and modified it a bit in multiple ways (view signature for referance). I recently encountered some some-what severe engine damage. The throttle had been "bogging" when-ever I tapped it, making it impossible to ride. Along with this...
  12. Sled Mods & Tech-Tips
    I have a 1999 zl500. It starts just fine and idles no problem. When I give it throttle, sometimes it'll run just fine and sometimes it will bog down. If it starts to bo and I let off the throttle, I can usually save it, but if I just hold the throttle it kills right out. Is it getting too...
1-12 of 13 Results
Top