Search Results for ‘belt’

Bought this sled a year ago for my wife and was wanting to replace the belt. Does not appear to look like anything I’ve seen on YouTube. Any help Is appreciated! Sled is a 2005 AC M7 141”. Attached are pictures of the secondary. Thanks! On the end it says AMP, not sure what this piece is, I’ve...

I own a 2015 450 xc and last week my belt blew (about 3600 km on bike). I bought an ultamax belt and installed it. Now my clutch case is getting so hot I can not keep my hand on it for more then a second. I checked intake/ exhaust and it’s all clear completely cleaned the case of any pieces of...

Hey all , my 2016 cat has been a bit of a nightmare . It started blowing belts around 145 hours , i have been through 4 now , 2 new drive faces, a set of rollers and a set of sliders, it seems to be getting so hot the internals of the primary are melting . however it seems to be getting worse as...

This past weekend i was out riding my 2013 mud pro 1000, going down an off road trail on a slight down hill grade at about 30-35 km/h, OUT OF NOWHERE, my quad came to a violent halt, I was thrown over the handle bars and the quad almost went end over end but tipped onto its left side and came to...

New to sledding and I have a 2006 F6 as my first sled, just put a new belt on and it chirps at idle and low RPM. Also creeps now. Belt too tight? How can I adjust?

Picked up a 01 auto the other day. I can tell the belt is slipping just from lack of power. Popped the cover and found that a new belt had been put on. The faces that move and drive the belt are glass smooth and have a pretty bad ridge in them towards the top. The clutches themselves dont have...

Hello, After 6.250 km on the stock belt, time has arrived to change it. Indeed the top speed droped from 92km/ at new to 83 km/h, but no slippage was noticed. Wear reduced its width to 26,8mm (29,5mm when new). I chose the Ultimax UA459 belt from Timken to replace the genuine Mitsuboshi...

Hi All, Blew belt this weekend while mudding. Was wondering if anybody can suggest a good severe duty aftermarket one or should I just stick to Arctic Cat belts? 09 TRV 1000, MP Snorkels, 2" RTR Lift, 28" Outlaw MST's, stock clutching Thanks.

Changed the belt on my f800, because I shredded my other one from it hitting a vent on the belt guard, idid everything that it said in a tutorial and now I just went to go ride n it doesn't have its snap like it did it moves pretty good but just doesn't have the power it did before. How tight...

This weekend's ride came to a premature end when the rev limiter suddenly limited me to 3500-4000rpm (25-30kph). Conditions at the time were uneventful - no big speed, no water, 2wd easy going but all at once tried to accelerate and couldn't. Have since confirmed the usual items including...

Hey guys looking for some advice , I have a 01 zr800 carb and both my clutches were junk (cracked secondary sheave and bushings in primary weights went bad so I got a new secondary and a comet 108xp primary for 350$ with a d&d single pipe clutch set up. ) I need a new belt and was curious what's...

Just got a sled and have been working on it, finally got out for a test run. On the trail it runs fine a little slow off the line but 10-60mph is no problem. But as soon as I stop in some powder or aimed up a hill the power is gone the clutch is spinning, but not engaging the belt to move the...

I've notice a burning rubber smell while plowing. Does it sound like a belt? Any recommendations? Thanks.

My sled has recently been eating belts. Ever since I flat-spotted and frayed my O.E.M. Belt all the way around, I've been using after markets! I bought a Day-Co (HP). and put on 40 miles and it would slip during clutch enguagement and while hill climbing. Needless to say, I was parking at Burger...

My sled is an all-around sled. It's built for everything! Riding, Aggressive Riding, Mountain, Climbing, and Boondockin'. Normally, I try to keep a constant pace to prevent the belt from slipping and flat-spotting and fraying, and to prevent the clutch from warping and the spark plugs from...

Hello world! I'm new to snowmobiling, and I recently bought a 2001 Triple Touring 600. Everything was working great until my sled froze to the ground during a lunch stop and I didn't realize it. I pressed the throttle a bit, and it didn't go. (I warned you I was a noob.) I did get it freed...

I blew my first drive belt since I got my sled. It came with a brand new arctic cat belt so I threw that one on there but now I'm not sure which kind to get. Is there a huge difference in performance between brands? Does anyone have any brands that they swear by? My sled is stock, except...