Arctic Chat : Arctic Cat Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. General ATV Discussion
    Hello I am no professional mechanic but I cannot for the life of me figure out how to get to what is left of the inner part of the right wheel bearing on the shaft of a AC 2001 4x4. Has anyone had experience with one that looks like this? I am assuming it is pressed on and off from the outside...
  2. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    2005 Z570 The lower bearing within my chain case gave out, and luckily I didn't discover damage to any other components. I decided to order all 4 bearing related to the drive train; both inside the chain case, the bearing at the secondary clutch and the bearing opposite the chain case (below...
  3. Wildcat
    i recently purchased a wildcat 1000 and i took it out the other day and there was a weird honing noise and didn’t think anything of it until my speedo stopped working it threw codes C1312 and P0500 also the honing noise goes away when i let off the throttle. i’ve read a couple threads and some...
  4. F/M/XF/ZR Procross Chassis 2012+
    I tried searching be couldn't find it sorry. I've got a 15 High Country 800, I need to do the driveshaft seal/bearing. Can it be done without removing the whole chaincase from the sled? Any tricks? I'll be doing the other side as well, any tricks to doing the one in the brake caliper? And info...
  5. Vintage 1992 & Older
    So pulling the drive axle on my 72 cheetah, having a hard time getting the chaincase end out, should the plate behind the bearing just slide off or do I need to pull the bearing off first?
  6. General Snowmobile Discussion
    For a sled with 2200 miles it sure is giving me a lot of trouble... Latest problem is this: ever since I bought it (a year ago) it skips when you punch it. When you accelerate quick and it digs down it skips, like it makes bout 6 or so quick clunks and screws up the acceleamration because then...
  7. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    Hi the speedo stopped working on my 2000 zr 500 and after pulling it apart I saw it was the key that broke. Since I need a new key I plan on replacing the bearing on the speedo side. I was wondering if I have to pull the jackshaft out to replace them or is there a way to replace it without...
  8. Utility ATV repair, maintenance, troubleshooting
    Question: To replace rear bearings, (2008 2-person, 550cc ATV) after removing wheel, axle nut and snap ring----then how do you remove the bearings? Axle moves back and forth maybe 1 inch. Any help appreciated.
  9. Utility ATV repair, maintenance, troubleshooting
    I was doing some routine maintenance to my wheeler and I noticed that my wheel bearings were all basically spent. Does anyone have any write ups on how to change the rear wheel bearings in a 1998 Arctic Cat 300 4x4? Are the front and rear the same setup?
  10. Firecat/Sabercat
    I have a 2004 f7efi. It's all apart I have the non chain case side bearings all pressed off the shafts and ready to put new ones on but bearing kit has a note about the new bearing seal beveled side goes against bearing face there wasn't an old seal kit p/n 1702-179/180 where does this seal go...
1-10 of 10 Results
Top