Arctic Chat : Arctic Cat Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-13 of 34 Results
  1. SnoPro Chassis 08-14 600/13-14 500
    I just picked up a 13 sx sno pro 600. Super excited to get this on the snow. I just picked up a set of xcs C&A pros along with 9 inch carbides. Just wondering if anyone has put something this aggressive on a sno pro and how did you like it ?
  2. CrossFire/CF/CFR 06-11
    The sled sat for the summer, excluding the few startups, i tried to start it a week ago, and it started fine after a few pulls. I let the sled warm up and suddenly it just turned off. I thought nothing and went to start the sled again but, nothing.. the dash wont turn on and the sled wont fire...
  3. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    Sled idles great, but once I give it gas it Boggs down and kills the motor. Just bought it a month ago and it ran fine. The computer light it flashing 2 times. water temperature sensor? How do I test it? TIA
  4. C-Tec2 talk Only
    Well, I'm wondering in what machine was the 600 ctech2 engine used first?
  5. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    Hey everyone. I have question about my ZR6000. We recently had our first snowfall here in Atlantic Canada and was pumped to get out. When I was riding on the trails my sled works perfect. Full power, great response, good speeds. etc. However when i was in the "deep" powder ( when I say deep i...
  6. M Series/Mountain Cat Pre 2011
    Is it worth dealing out the cash to put V-force reeds in my 01 mountain cat? I found that they are about $250. Will there be any improvements? I have read that fuel economy and crispness are gained but no actual power gain. Right now my sled seems a little weak in the low-mid throttle range but...
  7. General Snowmobile Discussion
    I need a snowmobile expert--- heres the problem.=== its a 1998 Arctic cat 600 powder sport. if you hang it, it runs like a champ. clutches are great. its fuel injected. as soon as its on the ground, it will idle great. track kick in right about 4500 RPM's as you accelerate, it goes ok but will...
  8. Performance/Racing
    I am building a zrt 600 drag sled in a completely different chassis. There would be problems trying to fit a jackshaft and chaincase in here. So we are thinking on direct drive. We would have the secondary on the speedo side and the brake on the chain side. We have access to a good machinist and...
  9. CrossFire/CF/CFR 06-11
    I have a 2006 Crossfire 600 and am going to be buying a 136 X 2 track for it very soon. I saw one for sale that has every third window closed. What I am wondering is if this will work for my sled? My last question is, does anyone know how these work in deep snow? I have heard pros and cons...
  10. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    I have an 98 ZL 440 and the engine is bad. I want to replace the engine with something bigger like 600 or 700. I understand that alot of motor are the same just different bores what should i look for to do this the easiest way possible? just wondering what blocks will fit and make this project...
  11. Z/ZL/ZR/ZRT/T-Cat/EXT/JAG/Cougar
    I'm looking at getting a sno-stuff rumble pack for my 2001 ZR 600 carbed VEV. I was wondering if you need to modify anything to make it fit? Has anyone had any bogging problems? What is the difference between single canister and triple canister rumble packs? Lastly, where should I get it from...
  12. Firecat/Sabercat
    Hello. Im new here and would like some help with my 03' firecat 700. I took the engine out and put a 07' crossfire 600 engine in and the coolant wont flow right. I put coolant in full and when i start it up the coolant willblow back out of the bottle. Anyone have a clue to what it could be? Hit...
1-13 of 34 Results
Top