Search Results for ‘2003’

Good morning everyone, new to the forum looking for some help. I have an ‘03 F7EFI. Some scumbags decided to steal the hood and cut the end of my wiring harness rather than unplugging it. Picked up a nice hood with speedo and lights off an 05 with diamond drive and he threw in a wiring...

Sup guys! I need a new seat for my 2003 ZR 900 and I found one that’s in perfect shape but it’s off a 2004 ZR 900. I was just going to buy the tank and seat complete since Arctic cat staples and glues the seat to the tank. I didn’t want to risk ruining the seat. But after doing some research I...

Hey guys, I have a 03 ZR 900 that i recently replaced the jack shaft on. So I had to obviously take the secondary off, all the gears in the chain case and the top bearing inside the chain case. After about an hour of trying to get the jack shaft out (holy rust!) I’m finally ready to reassemble...

I can;t get my sled to run one both cylinders : I cleaned the carbs, switched them from side to side, by-passed electrical hookup for carb, checked compression:115 pulling it over and if running on the one good side with plug out of other side the compression is 148, switched plug wires around...

hey guys, just got an 8" riser with 2" rise answer bars for my 03 f7, i got my brake line to reach by re routing it, my throttle cables to short to reach and ive ordered extensions but how can I get my kill switch and handwarmers to reach the higher barsI dunno, all help appriciated.

I adjusted the front shocks on my 2003 F7 sp. I raised the front end so the skis were off the ground. I backed the top retainer off until 2.5 inches of thread was exposed out of the top. I then raised the rear until the track was off the ground. I backed the spring on the front rear shock off...

my 03 f7 snopro, extended to 144" with 1.5" paddles stock clutches, engages at about 3600-3700 rpm, want a little bit more snap to it to keep up with my buddies f6 mod off the line, thinking about a stiffer spring and lighter weights to get it to fully rev out as its only hitting 7800 w/o, any...

What's up everyone. Looking at my 03' F7 today, I had a thought. I like to ride fairly aggressive and it's alot of leaning and shifting around since I ride northern New England trails. I have always noticed my feet slide around on the smooth foot boards. I am thinking about drilling 3...

Hey guys, I'm looking for some advice on coolings down my sno pro 440 for the trails, I do a lot of ditch riding and off trail riding, but do also go to northern NH and I'm wondering what the easiest solution is besides installing a f6/7 rear cooler, or if I even need to worry about 50-100mi...

I'm looking into adding additional cooling to my 2003 sno pro 440 to make it more trail friendly.. I don't a lot of ditch riding, but also take trips to northern NH and am worried about doing miles of riding on groomed trails with stock cooling system. I have read about f6/7 rear coolers but...

I picked up a 2003 Sno pro 440 that had a 03 F7 efi motor and wiring harness. I picked the F7 motor and harness out and sold them. Really struggling with the wiring up front for the 440. I have a 03 440 harness that origanly came out of the sled, along with the original motor. I cannot figure...