ArcticChat.com   ArcticChat Rules & Guidelines  Contact Us Gallery HelpSearchMembersCalendarLive Chat

Welcome Guest ( Log In | Register )



 
 Reply to this topicStart new topic
> 2001 200 4x4 burning oil
ryanjenkins
post Nov 3 2009, 02:20 PM
Post #1


Member
**

Group: Members
Posts: 7
Joined: 12-October 09
Member No.: 39239
My Location: baton rouge
Whats up guys I recently purchased a 2001 300 that seems to be burning a little oil but not to bad. I can smell it see a little smoke and when i get done riding I smell a little like oil. When i got the bike i changed oil and did not change oil filter i put synthetic 10w-40.

Does anyone have any suggestions as to why it is burning oil or anyone have any solutions to reduce burning oil other than doing engine work?

Thanks.
Go to the top of the page
 
+Quote Post
Wyo_H1_Cat
post Nov 3 2009, 02:46 PM
Post #2


Making H2 Lemonaide
Group Icon

Group: Team Arcticchat
Posts: 4303
Joined: 10-September 05
From: Wyoming
Member No.: 7914
My Location: Base of the Rocky Mountains
Your ATV: ThunderLemon 1000
2008 Mileage (ATV): Depends upon Failures
Only two ways for it to be burning oil. Worn valve guides or Worn piston rings. I would think the best possible way to remedy this is the engine work you referred to. Now there are those snake oil automotive products that claim to reduce oil burning, they may help, or may affect other internal parts in the ATV engine like the wet clutch? I don't know, I've never read where anybody has tried any of these products in a ATV or motorcycle with either positive or negative results.


--------------------

Show me a young conservative and I'll show you someone with no compassion.
Show me an old liberal and I'll show you someone with no intelligence.
Go to the top of the page
 
+Quote Post
Sanny651
post Nov 4 2009, 09:13 AM
Post #3


Advanced Member
Group Icon

Group: Sponsors
Posts: 17363
Joined: 30-September 05
From: Twin Cities, MN
Member No.: 8122
My Location: MN
Your Age: 37
Your Sled: 1996 and 1997 Polaris Indy Trails
Your ATV: 2007 650 H1 PSC Edition
Yep.....what Wyo said. Unfortunately, the only real way to cure the problem is to get into the motor. It's not hard, but it would need to be done to fix the problem.


--------------------
2007 650H1 PSC Edition

'08 Airbox----Speedwerx Cam----Speedwerx 11:1 High Compression Piston---Speedwerx Valve Springs---Ceramic Coated header pipe----Speedwerx Exhaust----Speedwerx Copper Exhaust Bushing----Koso Air/Fuel gauge ----Carb slide mod----4 coils clipped from carb spring--- Blue colored stock gauge with green needle by ///Airdam----2" Blue Digital Voltmeter and Water Temp gauges----HID's----14" ITP SS212 wheels with 27" Mudlite XTR's----Aluminum Diamondplate HosStoppers----Odyssey PC680 battery----4mm machined off of primary by ///Airdam----Gorilla axles----2.5" lift by MudTechInc. ----Heavy Duty Tie rods and steering stem by MudTechInc.----4th caliper/rotor on rear left corner---28" Outlaws for winter/fall riding


Click here for info on my Type 1 Mini Circuit Breakers
Click here for info on my UHMW Poly Shock Bushings
Click here for info on my UHMW Poly A-Arm bushings (with or without caster mod built in)
Go to the top of the page
 
+Quote Post
ryanjenkins
post Nov 4 2009, 12:48 PM
Post #4


Member
**

Group: Members
Posts: 7
Joined: 12-October 09
Member No.: 39239
My Location: baton rouge
Thanks guys.

Should i purchase the parts and then begin the work or should i pull the engine open it check it out and then order what i need ?

Around how much do these parts usually cost?

Go to the top of the page
 
+Quote Post
wicker_man
post Nov 4 2009, 03:33 PM
Post #5


Member
**

Group: Members
Posts: 36
Joined: 7-May 08
Member No.: 28690
My Location: sudbury
Your Age: 23
Your ATV: A/C H1 650
2007 Mileage (ATV): 800
2006 Mileage (ATV): 1000
I had an 06 400 that had the same problem i tried a few additives nothing worked at all. Brought it to the cat dealership and they had to over haul the engine it cost $4000 and the whole god damn summer lol
Go to the top of the page
 
+Quote Post
Archizzel
post Nov 4 2009, 05:09 PM
Post #6


Advanced Member
Group Icon

Group: Team Arcticchat
Posts: 121
Joined: 3-February 08
From: Canada
Member No.: 26250
My Location: Sudbury,Ontario, Canada
Your Age: 20
Your Sled: 1997 ZRT 600
08-09 mileage (Sled): 0 (So Far)
Your ATV: 2005 Arctic Cat 650 V2 LE
2009 Mileage (ATV): 500
2008 Mileage (ATV): 600
sounds like sbc ripped you off
Go to the top of the page
 
+Quote Post
wicker_man
post Nov 4 2009, 05:13 PM
Post #7


Member
**

Group: Members
Posts: 36
Joined: 7-May 08
Member No.: 28690
My Location: sudbury
Your Age: 23
Your ATV: A/C H1 650
2007 Mileage (ATV): 800
2006 Mileage (ATV): 1000
yea i made the mistake buying my atv there never again. Insurance covered it tho
Go to the top of the page
 
+Quote Post
fairlane_68
post Nov 4 2009, 06:10 PM
Post #8


Where's all the Canadian jokes?
Group Icon

Group: Team Arcticchat
Posts: 194
Joined: 14-August 09
From: Suffolk, Virginia
Member No.: 38247
My Location: Lawton, OK
Your ATV: '01 AC 300 4x4 running project
2009 Mileage (ATV): on hold
2008 Mileage (ATV): ---
2007 Mileage (ATV): -----
2006 Mileage (ATV): -------
QUOTE (ryanjenkins @ Nov 3 2009, 01:20 PM) *
Whats up guys I recently purchased a 2001 300 that seems to be burning a little oil but not to bad. I can smell it see a little smoke and when i get done riding I smell a little like oil. When i got the bike i changed oil and did not change oil filter i put synthetic 10w-40.

Does anyone have any suggestions as to why it is burning oil or anyone have any solutions to reduce burning oil other than doing engine work?

Thanks.

Same problem...mine smokes like a freight train. I'll probably dig into it this winter, after new years.


--------------------
'01 NakedCat 300 4x4
mods: (some assembly required)
new seat
12" Vision Mini-Truck rims
26" GBC Dirt Devil 2 XT's (rear)
25" Interco Swamp Lites (front)
CVMAN HD CV Axles
Moose 1.5" Lift kit
Moose Ball Joints
AC Chrome front bumper/brushguard
AC Chrome rear bumper
within-frame LED lighting
LED tail and corner lights
600CCA Car battery
Custom Fab front rack
Top end rebuild
more to come...
Go to the top of the page
 
+Quote Post
 

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 

Lo-Fi Version Time is now: 2nd September 2010 - 03:36 PM
Powered By IP.Board © 2010  IPS, Inc.
Licensed to: ArcticChat.com
More Sponsors
Become a Sponsor