Arctic Chat : Arctic Cat Forum banner

Clutch play

965 views 3 replies 2 participants last post by  skidoo440 
#1 ·
Is this normal. 06 f7 motor in a 04 sp440. All the f7 driveline is in place.
 
#3 ·
In my opinion that is excessive. Any amount of "float" over .120" is a lot. Anybody else wanna chime in?
 
#4 ·
On the jack shaft I purchased it had a rubber washer that helped with some shims. Also the cone shaped washer was installed with the narrow side to the clutch on the 440. On the f7 shaft I bought it had the wider side of the cone shaped washer towards the clutch. Which way is correct?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top