I have an 1982 Pantera that is super hard to start hot or cold. If I pull the left plug it will start up and run rough. If I reinstall that plug it wont start or is hard starting. If I install it while running it takes off and runs great. I have cleaned the carb, checked spark, changed coil, charged the battery, new fuel, ect ect
Does anyone have any ideas of what I can check? I'm doing a compression check in the morning. Someone has said to spray starting fluid at the back of the primary clutch if the rpm increases its a crank seal but this did not work out well, it blew all over.
Help
Does anyone have any ideas of what I can check? I'm doing a compression check in the morning. Someone has said to spray starting fluid at the back of the primary clutch if the rpm increases its a crank seal but this did not work out well, it blew all over.
Help