Quote: Originally Posted by swale
I wish to reset my tps on my 2009 tcat 1000 but am unsure how looked for info on how to get into the setup mode by jumping to wires on the connector onder the seat but am unsure exactly how ( as in which wires to join)
if like my 08, there is a six hole rectangle connector (2 holes by 3 holes) with only 3 wires in use other 3 are unused.
On the Short width (2 hole) of the connector there are two wires directly across from each other in each corner. on the long width three holes wide, there is a single wire in one corner. This one is not used.
O=wire in hole X unused hole in plug. bottom two are the ones you would jumper.