pinion bearing remove tool help!!!!!!!!!!!!!

[little red rooter]

i was wondering if any one new how to make one. its for the rear diff. and it takes of the retaining ring that holds the pinion and bearing in the rear diff.

theres an arctic cat dealer right up the street from me but there bing dicks about just taking if off for me.

i no someone on here made one with like a pipe end cap and a pipe welded to it. i need to no what size end cap it would be?

[Wyo_H1_Cat]

Actually just a large hex nut of the right size with an old socket welded on to it for ratchet attachment will work as a pinion bearing removal tool. I cannot remember the proper size to use though 48mm maybe? measure the distance from any to opposing flats across the center 180 degrees from each other

[arcticcat or die]

Yea its a special socket you need , that little thing costed me 60 bucks an used it twice ...GRRR